Simple mount for the Ikea "SKÅDIS" series of pegboards. This is intended for Wiha branded multibit "Ultra" drivers.
Designed specifically for Wiha's 77791 "Ultra" driver, but there are a variety of these with similar or identical molds; yours may fit if it differs only slightly.
The curved interior holds the driver in place, a pair of small detent assist in retention and provides a nice snap when inserted or removed. Works in either orientation.
Prints without supports and is surprisingly strong with just two wall layers, uses about 10g of filament.
Model shown was printed with cheap eSUN PLA+ filament.
Categories:
1 Likes3 DownloadsMarch 11, 2024
1 Likes3 DownloadsMarch 11, 2024