Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4804929.
Included designs for either 3D Printed or Lasercutting your own.##Installation is the same for either part.
I purchased an Ortur Laser Master 2 and found that the cables going from the laser module to the side of the machine kept getting stuck in the side and would either limit movement or get in the way of the limit switch and messing up homing. I tried another solution from Thingiverse only to find that Ortur must have enhanced the acrylic and the printed part would not fit.
I didn't want to go out and buy screws to attach something that should be simple so I resorted to designing my own part from scratch. I measured the black acrylic piece that fits behind the laser head and made a part that nicely fits over that. As a bonus, this uses very little filament and should print in about 30 min.
Additional Parts Needed:3 small zip ties
Assembly:- Place part behind the black acrylic piece next to the laser head.
- Secure in place using 2 of the zip ties.
- Bring the laser power cord over the top of the support beam, this reduces stress and gives stability to this cable.
- Using the 3rd zip tie secure the cords to the top end of the printed piece. If you have air assist you can also include the hose, no need to zip this too tightly, as long as it is supported you are good.
Now you can try moving your laser head to the side and you will see that the cords easily clear the edge with no more issues.
Edit: 4-12-2021 Added v2 with rounded corners on supports and edges to increase strength
Disclaimer: This item is free to make for personal use but may not be resold without permission. Those who have obtained permission will be listed here. https://www.etsy.com/listing/1001888067/hosewire-support-guide-for-ortur-laser?ref=shop_home_active_1