This is a collection of 4 low poly figures that are made to hold a standard size (22-25mm) D20 (20 sided die)
Most D20's fit. I've used a few different styles from different types of dice I've made.
These can be printed without supports, but I used supports because I always make a mess removing without them. If you do use supports, I recommend "light" and "ultra" if using a Slicer like Lychee. I rotated them to 45 degrees. I had a few fails mainly due to supports failing, as they are heavier.
The pictures show them after being removed from the wash and supports removed. I needed to use scissors to start, the rest,just my hands. I definitely need to sand them before painting. They are solid.
Categories:
10 Likes17 DownloadsSeptember 1, 2024
10 Likes17 DownloadsSeptember 1, 2024
Instructions
Filament
MaterialPLA
SupportsNone
BrimYes