Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4762351.

Add a lid to the open part of cover

Please print the following cover first https://www.thingiverse.com/thing:3184595

The lid is divided into an top side and a bottom side, and the two are connected for use.

• Adv3cc_top.stl x 1 The top lid.

• Adv3cc_bottom.stl x 1 The bottom lid. There is a hole for the guide tube(6mm) to pass through. 7mm width.

• Adv3cc_plate.stl x 1 It is a plate for connecting the top side and the bottom side.

• Adv3cc_nat.stl x 2 It is a nut for connecting the top side and the bottom side.

Others on the bottom lid .

• Adv3cc_btm_close.stl There is a no hole.

• Adv3cc_btm_h5.stl There is a hole for the guide tube(4mm) or filament to pass through. 5mm width.

• Adv3cc_btm_h2.stl There is a hole for the filament to pass through. 2mm width.