The spreadsheet and source code is hosted on github (https://github.com/dirtdigger/fleur_de_cali). See there for the latest versions of those. Stls will be kept up to date here. Additional sizes also available on github.

This is a free, open source, parametric tool used for adjusting the dimensional correctness and skew of your printer. This model performs a similar function to other prints such as Califlower, but has no relation to nor has been derived from any part of those. Turns out that the math behind printer skew calibration has been around since Euclid, and its application to 3D printers is well-documented on other open source project's websites like Klipper.

Parameters you can control within the Cadquery source code (located on github):

- Number of measure points for each axis, up to 5 (default 3)

- Thickness of the grid separator pieces (default is 4mm)

- Total width of the print (default 120)

- Height of the print (default 4mm)

Features:

- Parametric design. Try this with other calibration prints: scale up the model by 20%. You'll find your print time and material used increase by up to 50% since the thickness of the print also increases. Using this design, load up a different stl to keep the thickness the same. Your print time and material used only increase by about 20%

- Bigger is better. No calipers are perfect. Printing larger calibration prints decreases the relative error of your measurements. Included is up to 180mm full size, but make sure you've got calipers that can go that large before printing.

- Multiple measurement points. Measure as many locations as you want up to three times. If you get bored of measuring, stop. If you only want to measure two outermost points since they give the highest signal-to-noise ratio, do that. The spreadsheet is smart enough to figure it out. Just make sure for every outer measurement you have a corresponding inner measurement to offset incorrect flow calibration.

- Know when to stop. Along with offsets, error estimation based on the variance of your measurements and the error in your calipers are provided. If you're probably fixing noise, the spreadsheet will tell you.

Stl and step files that are included are all 4mm tall and have varying thickness depending on the size of the print. The files are named calistar_{print width}x{number of measurements per axis}.stl.

Measurement order is to measure from the outside in. This is described in more detail in the accompanying spreadsheet.

Calistar (formerly Fleur de Cali) - Open source printer size and skew calibration

calistar_120x3.stl

calistar_140x4.stl

calistar_180x5.stl

calistar_180x4.stl

calistar_150x5.stl

calistar_120x4.stl

calistar_150x3.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

realdirtdigger

Achievements

Seedling

Debutant

Calistar (formerly Fleur de Cali) - Open source printer size and skew calibration