Wheel cap for most of the cfmoto atv/utv/ssv models. It has a lower profile than the original one from the factory and fits perfectly in the rim. Thanks to that, it is hard to lose offroad in the mud. ;)

In some cases, there's not enough space for a such small cap, especially in front wheels. Many of my friends use those caps with distances installed.

I drove about 10k km with the cups which are visible in the picture with the rim (material: PET-G) - and it is still as good as new.

Update: Previously, that model was paid but it's my birthday, so I decided to make it free. Happy bday to me and thanks to you for your support and donations. ;) ** Recommended settings:** Print it in PET-G or other, stronger but springing material - the cap itself is quite robust but you may destroy the "arms" during insertion or removal of it.

If you decided to print in transparent filament use gyroid infill - imho the effect is the best.

Supports: YES Layer height: up to 0.3 mm (I haven't tested any bigger) Infill: 15%+ Wall lines: 3

Happy printing!