Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4935127.

I wanted to use an ADXL345 to measure resonances in Klipper in my Ender-3 V2 glass bed, but there is no easy way to attach it, so I designed this quick mount that will allow you to get the accelerometer aligned flat with the bed to avoid any vibration dampening effect.

There are 3 holes for M2*8 screws, ideally you should use at least 2 screws to ensure that the mount is completely secure against the bed.

My recommendation is to print it **UPSIDE DOWN** (orient the model so that the 3 holes are facing up) with support enabled:

 - Support structure: Tree
 - Tree support branch angle: 50
 - Support Overhand Angle: 55

ADXL345 Bed Mount

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4929290.

You will need a pneumatic connector for this to work, I recommend attaching the connector before assembling the holder on the printer as it might require some force to screw it in.

Ender 3 Filament Guide with Bowden Tube for WINSINN Dual Gear Extruder

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4870290.

Remixed to fit the KCD1 type button

KCD1 mount for Ender3v2

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4961769.

I've recently had a Landis+Gyr E470 smart meter fitted, but unfortunately it has not been able to connect to the network (bad signal inside) so I just built my own pulse LED sensor (based on Home Assistant Glow)

As I wanted to assemble the whole thing on top of the meter, I designed this harness to do it.

After printing, just take a small nail and manually puncture two holes side by side so you can fit the LDR wires through and then connect it to the ESP board.

Note: I know that a photodiode would be preferable, but I've been using an LDR with no issues at all, so that is why there's only 2 wires here.

Pulse LED sensor harness for Landis+Gyr E470 Smart Meter

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4913020.

Remix (designed from scratch) of the original as I found that it was small for the space on my Ender 3 V2

When I printed the original, I realized it was about 5mm short to cover the whole of the space in my Ender 3 V2 printer, so I redesigned it to fit the whole 40mm width.

Ender 3 V2 Cable Guard (40mm)

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4975998.

I have a few 5V 30A relays that I use with my printer, and I wanted to add an extra protection to the relay in order to not have any short circuits, so I built this small shell!

5V 30A 1 Channel Relay Module Shell

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

pedrolamas

Achievements