Designed this mount for my Ender 5 plus
the other camera mount had to much flex so I made his hard mount.
you might need to tweak the camera mount hold for your camera

This bracket was printed 35% infill
4grams a material I used PLA

Frame holes is 4mm bolts and T nuts
Camera hold is 3mm for re-cased c920s camera

I am not taking any copyright for this and freely sharing with for anyone who is looking for this kind of mount.


ender 5 plus camera frame mount

ender 5 plus camera frame mount.stl

Desk cone, Traffic cone, Stackable

A perfect distraction to deploy on your desk to stop people from messing with your work zone. LuLz

print settings.
.20
no supports.
Props to @DaddyWazzy_TheCreator for testing my design while my printers were unavailable

Desk Cone v2

Desk Cone v2.stl

This is a Star I designed to hang on the wall.

Per print is is nearly 50x50x8mm
nearly 3.5 grams each when printed as
5% infill / Gyroid / 1.2mm top layers

There is a notch in the back for upto a 2mm nail to hang from

Small Wall Star

Small Star.stl

This is a Star I designed to hang on the wall.

I printed this with Glow GiantArm Multicolor Glow

Per print is is nearly 150x150x15mm
nearly 40 grams each when printed as
5% infill / Gyroid / 1.2mm top layers

There is a notch in the back for upto a 2mm nail to hang from

Wall Star

Star.stl

This is a marker stand that I created.

it is designed to hold 15, upto 12mm in diameter colored pencil or marker.

each layer is printed separately to reduce the need to supports.

the design size is
Top |  205 mm x 100 mm x 12mm tall
Add | 205 mm x 100 mm x 20mm tall - Note 3mm is pushed into upper layer
Legs x2 | 100 mm X 10mm x 28mm tall Each -

Every Shelf has 4 5.5mm holes in the bottom to allow for more layers added below.
The posts on the Add shelf is 5mm allowing for easy fitment and can be glued there.

each shelf is roughly 65 grams with the settings
x2 legs is 9.1grams
PLA | Layer Height 0.2 | infill 10% grids | each print was roughly 6 hours on my ender 3 
I added a 4mm support in the middle of the 4 holes to allow them clean bridging 
during my printing.  please let me know how yours turns out.

I am unsure how to add the license,
you are welcome to share, use, sell, or whatever my design.

Update notes 3/19/2024 added Legs to allow you to raise the bottom shelf off the table

marker shelf v2 + legs

marker shelf top v2.stl

marker shelf add v2.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

notsodirt

Achievements

Seedling

Explorer

Debutant

ender 5 plus camera frame mount

Desk Cone v2

Small Wall Star

Wall Star

marker shelf v2 + legs