Rusty started on a production line back in July of 1986 and, due to some poor investments in the stock market and inflation, the factory was abruptly shut down mid August. Rusty, and all his friends, lay abandoned on the conveyor belts, completely assembled but Rusty was the last lucky robot to be programmed before the technician was forced to leave.

His luck ended there, however, as they were all locked inside the factory until just recently. Technically they function, they need programming, but most of all, they need a lot of love to overcome their abandonment issues.

Tested from 100 - 60% with no issues or supports required. I highly recommend a brim for 80% and less. Smaller prints might be weaker, and prints larger than 100% would likely require supports due to overhangs.

Available in 3mf and STL for multicolour or single colour printers.