Kegerator Pressure Regulator Dial w/Hole

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3701153.

The original regulator dial by rubisco2000 was great, except that my regulator's screw turns with quite a bit more resistance than most, apparently. As a result, the plastic rail that the flat-head screw slides into wasn't strong enough to hold the screw, even with the lock nut tightened into place. Therefore I needed a version of this with a hole in the face to allow me to tighten the screw down against the nut more securely.

A couple other, minor adjustments to this model:

• Reduced the size of the insertion holes to match the width of the screw head slide channel
• Removed the flat-head slot rail since it's no longer of any value

The modified SCAD document is also attached.