Qidi Plus 4 - Lid and Extra Bed Holder

A Simple Holder for the Qidi Plus 4 Lid and Bed. It is shown on the side of the printer but could be mounted on any flat surface. The back corner spaces the Bed to match the indent in the lid, but you could just use all rails. This used one corner in the back and four rails.

Vertical risers where added for better tape adhesion on the bottom rail. You should print two of these. I mounted it with Gorilla two-sided tape, and it is holding well so far.

It is printed in PLA with the default profile. It is just a quick design, but it has worked well enough I wanted to share it.