Ever since I saw the Creality Sprite pro Extruder I believe its PERFECT for a corexy printers . Here is my work in progress mount on my ender 6. I tested it and its working great!
Here is a video of it printing https://youtu.be/VuCKqtAE8nI
I believe It can be improve greatly with people having great 3d design skills than me. I'm Looking forward for others' improvement specially the wiring.
Also I did this mount on sketchup so If you need the raw file for improvement feel free to contact me.
WHAT YOU NEED:
Creality Sprite Pro (without the custom wires)
4 pcs 2 pin 1.2mm Jst female connector
1pc 4pin 1.2mm jst female connector for the extruder
1 pcs 2pin 2.0mm jst female connector - heater cartridge wire
4pc m3x8 bolts
Extruder wire extension
Depending on the extruder wire youve got from creality here is the color combination for the connector to the breakboard. (Please refer to the Extruder wire photo , please ingore the female jst connector color)
[black red blue orange] = extruder connectror ender 6 Breakout board from left pin to right pin
X,Y offset for Cr touch
X= 34.5
Y=0
Estep= 424.9 ( from creality you need to adjust accordingly)
IMPORTANT NOTE
As this is not yet perfect here are some important notes
-I needed to shave off 1mm off the Cr touch to make everything flushed to the x gantry
-You need to move the Y endstop back using this:
W/o top cover
https://www.thingiverse.com/thing:5205878
With Creality Top Cover
https://www.thingiverse.com/thing:5222477
-Also the filament tensioner is covered so you might have to drill a hole if you want its functionality
PRINTER SETTINGS
0.2 layer height
100% infill
Filament- I use ASA but you can use PETG or ABS
Just add a custom support on the CR touch mount