This is a filament painting of a beautiful tower covered in vines. It was made by using Midjourney. Printed at 110x220 @ 1.6mm
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
This is a customizable print, you can use 1, 2 or 3 layers of green to get different effects in the print. See the additional pictures for a better idea of the amount of green you can add. Check out the other layer suggestions below for what i used for the other options
Filaments Used:
PrintBed Black
Printbed White
PrintBed Gray
PrintBed Green
Swap Instructions: (default 2 layers of green)
Black until layer #7 at 0.64mm
Gray until layer #10 at 0.88mm
Green until layer #12 at 1.04mm
White for the rest.
Swap Instructions: (1 layer of green)
Black until layer #7 at 0.64mm
Gray until layer #10 at 0.88mm
Green until layer #11 at 1.04mm
White for the rest.
Swap Instructions: (3 layers of green)
Black until layer #7 at 0.64mm
Gray until layer #10 at 0.88mm
Green until layer #13 at 1.04mm
White for the rest.