My entry for 3D Printing Nerd's #3DPNSpeakerCover contest. Printed model pics here: https://www.prusaprinters.org/prints/60869-3d-printing-nerd-speaker-cage

I really liked the "high five" hands, so I modeled my own from scratch. I chose to make it so the hands were suspended by tulle fabric, with a similar process to this: https://www.youtube.com/watch?v=CjH5KGw3Psw

Printed with a 0.2mm layer height. I used PrusaSlicer to initiate a pause after the third layer was complete. Once it's done, you'll need to cut the tulle from the outside perimeter (maybe run a lighter around the outside to clean it up) and remove some material from the holes (it's there so that the holes can print cleanly without support).