Yet another filament dust filter here. The best one, if you ask me!
- Simple snap-fit design
- No screws or other fasteners needed, only the printed parts (and a piece of sponge)
- Can be hot-mounted onto a filament without fully reloading it (i.e. you could snap it onto a filament at any place; you don't need to thread the filament's open end through it)
- Fully parameterizable design with a FreeCAD source attached
Useful? Consider supporting me on GitHub 🤑.
Category:
4Â Likes13Â DownloadsDecember 2, 2023
4Â Likes13Â DownloadsDecember 2, 2023