This is a back-mounting cover for a Mamiya RB67. It attaches to the location where a film carrier would go, in case you want to protect your camera while it has no carrier connected.

I saw someone else had modeled this, but it was difficult to print without good reason.

Print this in standard orientation, no supports needed. I printed mine at 0.20mm layer height, ABS, 15% infill, no supports, no brim or raft.

I tried to also cut down on the amount of plastic used - it's an 18 gram print in ABS.

Licensed CC-BY-NC-SA

Mamiya RB67 Better Back Cover

RB67 Back Cover.stl

A very simple stand for the Floppy Emu Model C

It will keep your Floppy Emu from .. flopping around. 🤔 Too much, anyway.

Prints without supports. Pictured is PLA with 0.2mm layer height.

Designed for this:
https://shop.bigmessowires.com/products/floppy-emu-model-c

Floppy Emu Model C Frame Stand.stl

Floppy Emu Modele C Frame Stand.stl

Gridfinity module for holding the driver and extension from the old iFixIt 26 bit screwdriver kit.

It does not hold the 4mm bits.

Gridfinity iFixIt 26 Bit Screwdriver Holder

A stand for a safety razor. This model was designed to fit an Edwin Jagger DE89, but should fit other razors as long as the neck of the handle isn't too wide.

Safety Razor Stand

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

maddiefuzz

Achievements

Seedling

Trailblazer

Mamiya RB67 Better Back Cover

Floppy Emu Model C Frame Stand.stl

Gridfinity iFixIt 26 Bit Screwdriver Holder

Safety Razor Stand