Piranha Plant JoyCon Grip | Cartridge Holder

Wahoo!! I grew a Piranha Plant for you! Well known from Mario games. This one here may not be dangerous but it is very useful. Its head serves as a joycon grip and below it is a carousel for 10 nintendo switch cartridges. 🔴🎮

It is easy to print and assemble!

• I printed the pipe with the stem in two colors. If you have AMS it will be very easy to do. If not, just pause the print and replace the filament :)

• The second part of the tube you insert and twist, if you want a permanent connection use a bit of glue.

• The leaves are printed flat. You can use a hair dryer or heat gun to soften the leaves and fold them in the way you want :)

• You can print the joycon holder with brim to make sure it doesn't come off during printing

As always you will find additional photos in the attachment.

If you have any questions please message me 😊

Happy printing!! ✨ 3D PRINTING SETTINGS

Make sure your printer is calibrated and the heating bed is leveld for best results!

-Layer Height: 0.2 -Supports: NO -Infill: 10/15% (cross hatch In this case) -leafs were printed with 100% infill