This model is restricted by licensing terms.
View license.
66 Likes211 DownloadsJune 14, 2024
This model is restricted by licensing terms.
View license.
It originates from this other model of mine on Thangs
M2 / 2.5 / 3 / 4 / 5 / 6 / 7 / 8 / 9 / 10 / 11 / 12 on the front with screw holes
On the back there are hex slots to measure M2 - M12 nuts with corresponding size
It could measure screws length from 4 to 70 mm.
How to print (these are my specific Ultimaker Cura settings in 3mf project)
- 0.12 mm layer height
- 1 wall/perimeter count
- 15-20% infill
- slow print speed (50-80 mm/s) and slower speed on initial layers for better adhesion
- support (approx. 1 mm) for overhanging hex nut slots
Categories:
66 Likes211 DownloadsJune 14, 2024
This model is restricted by licensing terms.
View license.
66 Likes211 DownloadsJune 14, 2024
This model is restricted by licensing terms.
View license.