Daniel G

Filament Cleaner (Both 1.75mm and 2.85mm versions)

by
Modbot
Follow
Follow
Remix Model
lion7718
lion7718
|
|
Image 2 of 2
Filament Cleaner (Both 1.75mm and 2.85mm versions) - Cap 100%
Body is 20%, but I would do it again at 60%.
Use a little white lithium grease on the threads. - 3d model
lion7718
lion7718
|
|
Image 2 of 2
Filament Cleaner (Both 1.75mm and 2.85mm versions) - Cap 100%
Body is 20%, but I would do it again at 60%.
Use a little white lithium grease on the threads. - 3d model
2D
3D
Makes
Filament Cleaner (Both 1.75mm and 2.85mm versions) 3d model
Filament Cleaner (Both 1.75mm and 2.85mm versions) - Cap 100%
Body is 20%, but I would do it again at 60%.
Use a little white lithium grease on the threads. - 3d model
This model is restricted by licensing terms. 

Keep dust and debris out of your hotend with this filament cleaner.

I have some very old filament that has quite a bit of dust on it that I want to avoid getting into my printer. I designed this simple print which will allow you to insert a sponge into the canister and then push your filament through. Doing so should really help make sure the only thing going into your printer is the intended filament.

Went through a few revisions and am very happy with the end result. There are two versions with one for 1.75mm and one for 2.85mm filament.

I printed at .2 layer heights in PLA and the threads worked very well.


161 Likes1.3K DownloadsSeptember 27, 2021


161 Likes1.3K DownloadsSeptember 27, 2021
This model is restricted by licensing terms.