This model is restricted by licensing terms.
View license.
This is a statue of a bull. It looks great as a decoration and prints very easily.
Recommended print settings
- layer height: 0.1 mm
- infill: 10% gyroid
- perimeters: 3
- seam position: random
- supports: no
I was able to print it without supports, and it came out perfectly at this layer height. But there is one place on the underside that may require supports on a thicker layer height.
Category:
39 Likes88 DownloadsSeptember 1, 2023
39 Likes88 DownloadsSeptember 1, 2023
This model is restricted by licensing terms.
View license.