tracking pixel
kosteklvp

Raspberry Pi 3A+ Case

by
kosteklvp
Follow
Follow
Remix Model
kosteklvp
kosteklvp
|
Image 5 of 12
Raspberry Pi 3A+ Case 3d model
kosteklvp
kosteklvp
|
Image 5 of 12
Raspberry Pi 3A+ Case 3d model
2D
3D
Makes
Raspberry Pi 3A+ Case 3d model
Raspberry Pi 3A+ Case 3d model
Raspberry Pi 3A+ Case 3d model
Raspberry Pi 3A+ Case 3d model
Raspberry Pi 3A+ Case 3d model
Raspberry Pi 3A+ Case 3d model
Raspberry Pi 3A+ Case 3d model
Raspberry Pi 3A+ Case 3d model
Raspberry Pi 3A+ Case 3d model
Raspberry Pi 3A+ Case 3d model
Raspberry Pi 3A+ Case 3d model
Raspberry Pi 3A+ Case 3d model
This model is restricted by licensing terms. 

This is a case for Raspberry Pi 3 Model A+ and Raspberry Pi 1 Model A+.

The dimensions of the case are 72 mm x 60 mm x 20 mm. It consists of two parts (a base and a lid) and has been designed to be fully covered with only cutouts for ports. It's easy to print and assemble. It doesn't require any additional screws or joints.

Recommended print settings

  • layer height: 0.2 mm
  • perimeters: 2
  • solid layers: 5
  • infill: 20% grid
  • supports: no

Assembly instructions

  1. Insert microSD card into Raspberry Pi.
  2. Insert Raspberry Pi into the base. Side with HDMI, microUSB and mini Jack ports should be inserted first.
  3. Assembly lid. A little connector should be inserted in the place where the USB port is located.

The lid should fit quite tight, but it should also disassemble from the base without using too much force.


39 Likes130 DownloadsFebruary 20, 2022



39 Likes130 DownloadsFebruary 20, 2022
This model is restricted by licensing terms.