This is a case for Raspberry Pi 3 Model A+ and Raspberry Pi 1 Model A+.

The dimensions of the case are 72 mm x 60 mm x 20 mm. It consists of two parts (a base and a lid) and has been designed to be fully covered with only cutouts for ports. It's easy to print and assemble. It doesn't require any additional screws or joints.

Recommended print settings

• layer height: 0.2 mm
• perimeters: 2
• solid layers: 5
• infill: 20% grid
• supports: no

Assembly instructions

1. Insert microSD card into Raspberry Pi.
2. Insert Raspberry Pi into the base. Side with HDMI, microUSB and mini Jack ports should be inserted first.
3. Assembly lid. A little connector should be inserted in the place where the USB port is located.

The lid should fit quite tight, but it should also disassemble from the base without using too much force.