This is a 45 x 45 square grid with 3 different patterns. This was used for a skirt. A total of 8 full panels were printed, attached together with UV curable resin, and then sewn onto a base material. I get this multi color finish by using an AMS unit from Bambulabs with my P1S / P1P printers. You can easily change the colors of the pattern, or recolor them yourself if you have that skillset. I use a two way polymesh material for the best fit.
This print is .64mm high. I use a .4mm nozzle and .2mm layer height. The first layer is .24mm, there is a pause built in before the second layer starts where a thin mesh fabric must be set and held in place by either magnets or tape. The print is then resumed, and completed on the third layer. These layers generally need to be printed at slower speeds. My average is 50mm/s (as low as 35mm/s), with a hotend temp around 220. I like using a build plate with a holographic effect, but the textured effect can be just as cool.