Houndstooth topper for beanie
This is the file for a Houndstooth patterned hat topper. This is for printing on a build plate of 256mm x 256mm or larger.
You'll need a mild to moderate level of 3D printing, in addition to basic sewing skills.
This print is .64mm high. I use a .4mm nozzle and .2mm layer height. The first layer is .24mm, there is a pause built in before the second layer starts where a thin mesh fabric must be set and held in place by either magnets or tape. The print is then resumed, and completed on the third layer. These layers generally need to be printed at slower speeds. My average is 50mm/s, with a hotend temp around 220. Pay careful attention of the prime line, or any other calibrating line that may be extruded, as this model takes up the entire build plate and I have often missed it.
To get the finish of your choosing, take a peek at these magnetic PFLAT sheets that I use to imbue the effect of my choice https://kaizen3dprints.com/collections/p-flat-plates
Additional info in the PDF guide included
Houndstooth topper for beanie
Hand sewn vertical wallet
256x256 PFLAT sheet holder
Massage Roller
Spinning gear fidget ring
Flat band fidget ring
Large TPU foldover bag
Adjustable Strap (48"/122cm max length)
Small Foldover Bag
Customizable Passport Wallet
Tall TPU Bifold Wallet for sewing
Vertical Wallet for Chicago Screws
Square Grid Negative Modifier
Hex Grid Fabric Modifier
Heart Pixel Pattern Textile and Modifiers
Vertical TPU wallet with rivets and grommets
Flippy heart textile and modifiers
Foldable TPU bag sized for Snapmaker U1
Crossed Basket Weave Textile / Modifier
Thin Beaded Textile / Modifier
i love this design! i am wondering what are you using for a liner?
Thanks! I just put it directly over a premade beanie, I found these fit adults heads pretty well if printed on a stretch fabric