Hat negative part modifier
109 downloads · 1 year ago · This is a hat negative part modifier. Use it with a 3D textile pattern of your choice. I'm currently
This model is restricted by licensing terms.
View license.
This is a hat negative part modifier. Use it with a 3D textile pattern of your choice. I'm currently printing it up with the new Dice lattice textile. Load in your textile of choice and load this STL file in as a negative part modifier to print just what you need. You can resize the negative part modifier to fit your size hat.
After you print two copies, sew them right sides together using a stretch stitch setting, or a zig zag stitch if a stretch stitch is unavailable.
I recommend using a polymesh or powermesh material for these prints. I like putting two snap fasteners on them for easy transition between hats.
Hat negative part modifier
109 downloads · 1 year ago in and
This model is restricted by licensing terms.
View license.
Hand sewn vertical wallet
256x256 PFLAT sheet holder
Massage Roller
Spinning gear fidget ring
Flat band fidget ring
Large TPU foldover bag
Adjustable Strap (48"/122cm max length)
Small Foldover Bag
Customizable Passport Wallet
Tall TPU Bifold Wallet for sewing
Vertical Wallet for Chicago Screws
Square Grid Negative Modifier
Hex Grid Fabric Modifier
Heart Pixel Pattern Textile and Modifiers
Vertical TPU wallet with rivets and grommets
Flippy heart textile and modifiers
Foldable TPU bag sized for Snapmaker U1
Crossed Basket Weave Textile / Modifier
Thin Beaded Textile / Modifier
What printer do you use to print a whole side of the hat? I assume for an adult size using a bambu, I'd need to cut each side in half to fit the bed. So 4 pieces? correct?
I used the h2d for this version to make it a little easier on myself, but they can be printed on the p1s in two halves, albeit the fit may be a little snug. You could definitely split the model in half and print it in four pieces!