Adjustable Strap (48"/122cm max length)
This is a 3D printed adjustable strap to be used for purses, bags, accessories, etc.
The strap needs to be printed in a flexible filament. I've had success with a range of shore hardness levels. I think my personal preference is in the 85-90a range.
The hardware is to be printed in a rigid material. I prefer to print the hardware in HTPLA, PETG, or PLA+.
There are three versions to choose from. The first uses E6000, superglue, or your preferred adhesive. The second uses 6mm cap width x 5mm post length rivets, although similarly sized rivets can work as well. The third uses a simple saddle stitch technique to sew the ends together after the swivel clasp hardware has been attached.
It takes around 3 hours to print and 5-10 minutes to assemble.
Please refer to the photos and video included for additional guidance on how to assemble these straps.
If you have any questions, please send an email to Kaizen3DPrints@gmail.com
Adjustable Strap (48"/122cm max length)
Abstract art #2
Hand sewn vertical wallet
256x256 PFLAT sheet holder
Massage Roller
Spinning gear fidget ring
Flat band fidget ring
Large TPU foldover bag
Small Foldover Bag
Customizable Passport Wallet
Tall TPU Bifold Wallet for sewing
Vertical Wallet for Chicago Screws
Square Grid Negative Modifier
Hex Grid Fabric Modifier
Heart Pixel Pattern Textile and Modifiers
Vertical TPU wallet with rivets and grommets
Flippy heart textile and modifiers
Foldable TPU bag sized for Snapmaker U1
Crossed Basket Weave Textile / Modifier
Thin Beaded Textile / Modifier
