J

Thule Stroller Cup Holder

by
jpatrick
Follow
Follow
Remix Model
Thule Stroller Cup Holder 3d model
Thule Stroller Cup Holder 3d model
2D
3D
Makes
Be the first to upload a Make

A cup holder compatible with Thule Spring and Thule Shine. Holds a 40oz water bottle or a 30oz Yeti Tumbler.

Stroller attachment point taken from MottN's Thule stroller cup holder (Spring and Shine). Fusion360 model attached.

If I reprint this I may remake this with the following modification:

  • Shorten model :: It was printed to accommodate my 295mm tall water bottle. Shrinking it by 30% shouldn't affect its efficacy would reduce bulk.
  • Shorter bottom well :: Its far deeper than it needs to be.
  • Recess mount point :: Currently this must be printed with supports. Adding a recessed mount point should allow it be printed on its back without supports.
  • Partial Bottom well :: Cutting of 1/3 of the width of the well should reduce the footprint when not in use, and & eliminate the need for drainage

0 Likes4 DownloadsMay 31, 2024



0 Likes4 DownloadsMay 31, 2024