jmckerna

Moon Base Alpha - Phil A Ment Stand

by
jmckerna
Follow
Follow
Remix Model
jmckerna
jmckerna
|
|
Image 1 of 5
Moon Base Alpha - Phil A Ment Stand 3d model
jmckerna
jmckerna
|
|
Image 1 of 5
Moon Base Alpha - Phil A Ment Stand 3d model
2D
3D
Makes
Moon Base Alpha - Phil A Ment Stand 3d model
Moon Base Alpha - Phil A Ment Stand 3d model
Moon Base Alpha - Phil A Ment Stand 3d model
Moon Base Alpha - Phil A Ment Stand - showing how to use the clips to sturdy up the base plates when expanding the stand - 3d model
Moon Base Alpha - Phil A Ment Stand 3d model
This model is restricted by licensing terms. 

This is a modular stand for your Phil A Ment test prints given they are printed at 50%. I sized Phil to 50% because that puts him at a size very similar to a basic 3DBenchy print.

The stand can be expanded horizontally and/or vertically using the "mending plates" and M3 screws (I used M3 hex socket button head cap screws). Typically I used M3x12mm or M3x14mm for the screws that go into the base plates and no longer than M3x8mm screws that go into the top of the backs to connect the next level above. There are also small clips that can be used to keep the base plates straight and not separate at the front. The clips come in large and small sizes although printing in PLA the small size typically works best. The large is provided for a slightly tighter fit.

The "tray" pieces are mirrored so they will seamlessly go side to side looking like continuous moon surface if you alternate between tray A and tray B.


4 Likes11 DownloadsAugust 27, 2021


4 Likes11 DownloadsAugust 27, 2021
This model is restricted by licensing terms.