PokDemon

I've sculpted this famous character in ZBrush just for fun even though I've never seen a single episode. What I know however is...

This guy dosn't like to be inside PokeBall.

Body & Tail

Supports preview image

• 0.2 mm layer height
• Both models need supports.I've used Auto Tree supports with Treshold Angle of 40 degrees for both

Horns & Back inserts

Supports preview image

Use brown filament for both

Horns

• 0.15mm layer height since they are little bit more detailed than the body
• use Auto Tree Supports with Treshold Angle of 40 degrees
• glue them onto the head

Back inserts

• no supports needed just glue them on the back of the body

Eyes and Blood inserts

Eyes and blood detail image

These are quite delicate small parts therefore print them with:

• 0.1 mm layer height
• 20mm/s speed

Slicer preview image

I've printed blood inserts already in red filament and eyes were printed in white. Than I've just painted iris with black permanent marker. When done just glue them to the head.

PokeBall

Slicer preview image

PokeBall is precutted. Just print it how it is and break it when print is finished

• 0.2mm layer height
• use Red, White and Black filament
• glue black and red pieces together - this is mini puzzle for you to figure out 😉

Base

Slicer preview image

• separated to 3 models so you can print it using Blue, Yellow and Light grey filament
• no supports
• 0.2mm layer height

Final assembly

Glue the body to the Base and insert some Pokeball debris under left leg. Spread other pokeball pieces however you want. I've used hot-glue gun for this final assembly.

Enjoy.