Generic square shaped key, often used for storage area access in communal living spaces, Bins storage areas etc.

Model has several slots for button magnets so it can be made into a fridge magnet, very convenient!

Generic Square Key, Communal Areas, Bins Storage etc.stl

Three part ashtray bin, designed to be stuck onto a flat surface. Easy remove to Empty & Clean

Easy Empty Exterior Ashtray

Ashtray Body.stl

Holster/Holder for the Ubiquitous Samsung TV remote. Designed to be cable tied to an upright column/shelving, lamp etc.

Samsung TV Remote Control Holster.stl

STL and .ipt files for Peli Style Toolcase Organiser

I have been trying to find a cheap but smart solution for organising my tools in my Peli Style toolcase.

I found a few off the shelf versions, I particularly liked this product from TrekPak.

However the cost was extremly offputting given the materials they used. I wanted something clean and configurable but cheaper. Preferably with materials I already had to hand.
The inserts are made up of a total of 6 different parts. The minimum parts to make the inserts are:

Quantity	Part	Colour
4 x	Part A	Light Blue
2 x	Part B	Dark Blue
2 x	Part C	Green
2 x	Part D	Purple
10	Parts Total	
Part B is glued between 2 x part A to make up one of the horizontal dividers.

Part C and Part D are glued together to make up one vertical dividers.

Additional horizontal and vertical dividors can be printed as required.

Part E and F (Pink) are shorter row dividers and can be printed as required to splitting up rows into shorter sections.

This was done to make sure the parts could be printed on smaller printers. I dont think any part is larger than 150mmx150mm

All parts are 7mm wide, and so far seem strong enough to work for this purpose.



Find all finished STLs in V1.0 Parts folder

Print Settings
I am using an AnyCubic S3, and I have chosen to print each part standing up. With my current print settings in cura:

Setting	Value
Layer Height	0.2 mm
Print Speed	50mm/s
Infill	18.0%
Infill Pattern	Gyroid
Build Plate	Brim
Brim Width	8.0 mm
The average parts are coming out as just under 5 hours of print time, and uses approximately 50g of PLA.

Total print time for my use will be ~ 65 hours!

Costing and Materials
Using the settings above, I would expect the minimum frame to use just over 500g of material, therefore it will use about half a roll of PLA, and cost me about £12.50 in raw material costs. Even with an additional long divider and a couple of the shorter dividers, the whole lots shouldn't cost more than a single reel of PLA, making it much cheaper than the off the shelf alternative I found earlier.


Peli Style Toolbox Organiser (Set)

PART_A_hoz_V1.2.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

imogen.wren91

Achievements

Seedling

Generic Square Key, Communal Areas, Bins Storage etc.stl

Easy Empty Exterior Ashtray

Samsung TV Remote Control Holster.stl

Peli Style Toolbox Organiser (Set)