Dyson Corrale, Straightener, Holder
Note on Design
This item holds the Dyson Corrale Hair Straightener and charging cable. It attaches to a multiboard tile using two 13mm small shank screws. The unit is intended to mount horizontally. I'll note that I have some ideas for this to be vertically mounted but will revisit if there is enough interest in the item.
To install the charging cable slide the thinnest portion into both slots and pull the cable back until it is flush with the face that touches the charging side of the Corrale. See photos to help visualize.
Things to Print This item uses two 13mm small screw shanks to mount to a multiboard.
Optional Things to Print Something I find quite useful is to wrap up the charging cable. Using two right angle pegs and two weight bearing snaps (top up and bottom down). You can make a pretty nifty cable wrap.