An enclosure for an ETC Gadget.

Uses M3 heat set inserts, with M3-10 flat head screws for assembly. Uses a length of clear filament as a light pipe to make the status light on the Gadget visible externally.

BOM: Neutrik:

• 2x NC3FD-L-1
• 2x NC5FD-L-1
• NE8FDV-Y110
• NAHDMI-W-B
• NAUSB3

Not Neutrik:

• USBC type D passthrough
• USB Hub (Anker 533)
• 2x Low profile 5pin XLR
• USB 3 cable (both ends bend right)
• USB 2 cable
• Ethernet cable
• Ribbon HDMI Cable (1 end down, 1 end straight, 10cm cable)
• Airtag (optional)
• M3 heat set inserts
• M3x10 flat head screws

Onshape link.

Images