Natalie C

Flame Tea Light Holder

by
3dprintbunny
Follow
Follow
Remix Model
ibezoe
ibezoe
|
|
Image 4 of 6
Flame Tea Light Holder - I forgot to take the bottom layers out when slicing.
Still turned out really well.
I think I’ll heat up the soldering iron and poke a hole in the bottom and shove some fairy lights inside.
Thx for the great file - 3d model
ibezoe
ibezoe
|
|
Image 4 of 6
Flame Tea Light Holder - I forgot to take the bottom layers out when slicing.
Still turned out really well.
I think I’ll heat up the soldering iron and poke a hole in the bottom and shove some fairy lights inside.
Thx for the great file - 3d model
2D
3D
Makes
Flame Tea Light Holder 3d model
Flame Tea Light Holder 3d model
Flame Tea Light Holder 3d model
Flame Tea Light Holder - I forgot to take the bottom layers out when slicing.
Still turned out really well.
I think I’ll heat up the soldering iron and poke a hole in the bottom and shove some fairy lights inside.
Thx for the great file - 3d model
Flame Tea Light Holder 3d model
Flame Tea Light Holder 3d model
This model is restricted by licensing terms. 

A flame inspired tea light holder

Both parts print in vase mode. With the top, set your bottom layers to zero so that it prints without a base.

There are two heights of base to choose from and the width of the base also means you can fit the 70mm round battery lights in there too.


116 Likes362 DownloadsAugust 13, 2022


116 Likes362 DownloadsAugust 13, 2022
This model is restricted by licensing terms.