3dprintbunny

Select a membership plan

Monthly billing

17% off

Supporter Plus

Supporter Plus

$8.33

/ month

when billed annually

This supporter plus plan gives you:

A MASSIVE thank you for your support
Access to a small library of exclusive designs including my Hot Air Balloon and Carousel designs
One new exclusive design monthly
Opportunity to suggest and request new designs
Advice and support

Immediate access. Cancel anytime.

17% off

Commercial Print & Sell

Commercial Print & Sell

$9.96

/ month

when billed annually

This membership plan gives you the right to print and sell any of the 3DPrintBunny designs available for download on the Thangs website. It also gives you the right to print and sell any 3DPrintBunny design available on any other website (Printables, Makerworld etc). These rights are limited to the duration of your membership

You also get:

Access to a small library of exclusive designs

this membership does not permit the use of any 3DPrintBunny design to promote products other than the design itself*

Immediate access. Cancel anytime.The models in this plan are restricted by licensing terms. View License.

3dprintbunny24K followers

Follow

Flame Tea Light Holder 3d model

Flame Tea Light Holder 3d model

Flame Tea Light Holder 3d model

Flame Tea Light Holder

431 downloads · 4 years ago · A flame inspired tea light holder Both parts print in vase mode. With the top, set your bottom lay

This model is restricted by licensing terms.

View license.

A flame inspired tea light holder

Both parts print in vase mode. With the top, set your bottom layers to zero so that it prints without a base.

There are two heights of base to choose from and the width of the base also means you can fit the 70mm round battery lights in there too.

Community Makes (2)

Make by user

I forgot to take the bottom layers out when slicing.
Still turned out really well.
I think I’ll heat up the soldering iron and poke a hole in the bottom and shove some fairy lights inside.
Thx for the great file

Make by user

I forgot to take the bottom layers out when slicing.
Still turned out really well.
I think I’ll heat up the soldering iron and poke a hole in the bottom and shove some fairy lights inside.
Thx for the great file

Community Makes (2)

Make by user

I forgot to take the bottom layers out when slicing.
Still turned out really well.
I think I’ll heat up the soldering iron and poke a hole in the bottom and shove some fairy lights inside.
Thx for the great file

Make by user

I forgot to take the bottom layers out when slicing.
Still turned out really well.
I think I’ll heat up the soldering iron and poke a hole in the bottom and shove some fairy lights inside.
Thx for the great file

Discussions

Doodles2 years ago

3d model

3d model

Plainbum4 years ago

Gorgeous!

tanlarkurgu4 years ago

tanks for sharing 3d model

Flame Tea Light Holder

431 downloads · 4 years ago in

Lamps & Lighting

and

Home Decor & Accessories

3dprintbunny24K followers

Follow

This model is restricted by licensing terms.

View license.