Hebert G
Awarded to:hebertu
First Make published
DigitalDigital Store
Bundle
PrintsPrint Store
My Thangs
Access 15,000+ models$14.99/month
DigitalDigital Store
Bundle
PrintsPrint Store
My Thangs
Access 15,000+ models$14.99/month
profile hero image
hebertu’s profile picture

hebertu

0 followers0 downloads

Achievements

First Make published badge
Novice Maker
First Make published
10 Models downloaded badge
Explorer
10 Models downloaded
All
Sort by:

Modern Mushroom Lamp

Modern Mushroom Lamp - Hi, I would like to report two issues I’m experiencing while printing this model. The first problem happens around the base of the lampshade. There is an uneven variation around the circumference in certain areas, creating visible irregularities in the surface finish. The second issue occurs near the end of the print. On the inner wall, always in the same location, the printer does not properly fill the layer, leaving a consistent gap/defect in that specific area. Both issues seem to repeat consistently in the same spots. Could you please advise if this might be related to the model geometry or if there is a recommended print setting to correct it? Thank you in advance for your support. - 3d model