Use for mounting LED taillight under the seat. 

Ruckus_taillight_mount.stl

use these as spacers for the Ruckus Radiator cover. be sure to tweak slicer setting to make hole .5mm bigger when i printed the hole was slightly too small (although i did get it to work making it bigger will be easier)

Spacers for Rad Cover

Radiator Cover and spacers for Honda Ruckus 50cc. 
check my other uploads for spacers.
will need longer screws or make spacers shorter. Also the holes were barley big enough to get the screws through, i got it to work but you could tweak slicer settings to make holes bigger (in cura this could be achieved by a +.1 in "outer wall inset" or +.05 in "hole expansion")

Ruckus_rad_cover2.stl

Radiator Cover and spacers for Honda Ruckus 50cc. 

will need longer screws or make spacers shorter. Also the holes were barley big enough to get the screws through, i got it to work but you could tweak slicer settings to make holes bigger (in cura this could be achieved by a +.1 in "outer wall inset" or +.05 in "hole expansion")

Print with solid infill and use a 6mm airsoft or steel bb as the tip. My longest spin with airsoft bb was 2:06

Spinning Top

USB/SD card Dektop Organizer

usb_sd_organizer (1).stl

I 3D print stuff and sometimes try to design. Here is some stuff I have done.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

georgerobert86

Achievements

Seedling

Debutant

Ruckus_taillight_mount.stl

Spacers for Rad Cover

Ruckus_rad_cover2.stl

Spinning Top

USB/SD card Dektop Organizer