tracking pixel
gazzaladra

Sponge holder

by
gazzaladra
Follow
Follow
Remix Model
gazzaladra
gazzaladra
|
Image 3 of 5
Sponge holder 3d model
gazzaladra
gazzaladra
|
Image 3 of 5
Sponge holder 3d model
2D
3D
Makes
Sponge holder 3d model
Sponge holder 3d model
Sponge holder 3d model
Sponge holder 3d model
Sponge holder 3d model
This model is restricted by licensing terms. 

A useful sponge and cloth holder for a tidy kitchen. Just throw your wet cloth on top and place the sponge and scourer below. The grid is easy to remove to clean the drip tray. I started using solid dishwashing soap for less plastic waste – they can also be placed on the grid.

Size assembled: 240 x 96 x 220 mm This is the V5

Print settings Required build volume: 240 x 240 x 100mm ( works on a P1P if you move it a bit from the center) Material usage: 130g

Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 15% Build plate adhesion type: none

Watertight printing - If you have a well set up machine it comes automatically - Otherwise here are some tips: Increase your wall count (at least 3), level your bed nicely, decrease print speed, increase layer height (at least 0.2mm), check your seam quality, calibrate your e-steps and fine tune your retraction settings to make sure no holes appear after a layer change.


52 Likes92 DownloadsNovember 14, 2023


52 Likes92 DownloadsNovember 14, 2023
This model is restricted by licensing terms.