A useful sponge and cloth holder for a tidy kitchen. Just throw your wet cloth on top and place the sponge and scourer below. The grid is easy to remove to clean the drip tray. I started using solid dishwashing soap for less plastic waste – they can also be placed on the grid.
Instructions
- Print two bodies, holders and grids (they are symmetrical)
- Print five hooks
- Connect the parts with the hooks by pushing them in with a little force
Size assembled: 262 x 90 x 223 mm This is the V4 Don't forget to post your makes
Print settings Required build volume: 200 x 200 x 50 mm Material usage: 130g for all parts Print time: 14h for all parts
Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 15% Build plate adhesion type: none
Watertight printing - If you have a well set up machine it comes automatically - Otherwise here are some tips: Increase your wall count (at least 3), level your bed nicely, decrease print speed, increase layer height (at least 0.2mm), check your seam quality, calibrate your e-steps and fine tune your retraction settings to make sure no holes appear after a layer change.