tracking pixel
gazzaladra

Soap dispenser “bubbles”

by
gazzaladra
Follow
Follow
Remix Model
gazzaladra
gazzaladra
|
Image 7 of 7
Soap dispenser “bubbles” 3d model
gazzaladra
gazzaladra
|
Image 7 of 7
Soap dispenser “bubbles” 3d model
2D
3D
Makes
instagram-play
Soap dispenser “bubbles” 3d model
Soap dispenser “bubbles” 3d model
Soap dispenser “bubbles” 3d model
Soap dispenser “bubbles” 3d model
Soap dispenser “bubbles” 3d model
Soap dispenser “bubbles” 3d model
Soap dispenser “bubbles” 3d model
This model is restricted by licensing terms. 

A beautiful soap dispenser intended for refilling. Upcycle a dispenser of a used soap bottle to create this piece. Avoid some plastic waste and have a unique soap dispenser in your bathroom! Single and multi-color printing models are included as STL and 3MF! They work with all current and usual multi color setups. Fill Volume: 300ml

Step-by-step

  • Find an empty soap dispenser bottle and unscrew the pump. Alternatively, you can buy high end looking pump, too.
  • Measure the diameter of the opening of your pump where the thread sits.

The threads of these dispensers are standardized. Most widely used are GPI/SPI Neck finishes. I included the two most common types that fit the majority of such pumps. Soap_dispenser_A: fits 28/400 28/410 28/415 threads with a pump opening width of approximately 28 mm (1,1 inch) that fits bottle mouths of 26 - 28 mm (1.02 – 1.10 inch) Soap_dispenser_B: fits 24/400 24/410 28/414 threads with a pump opening width of approximately 24 mm ( 0,95 inch) that fits bottle mouths of 23 - 24 mm (0.90 – 0.95 inch)

  • Choose your file and print it
  • Check the length of the pump tube. If the original bottle was about 250 – 400 ml it should fit. If you use a pump intended for a originally bigger bottle (f.e. 500ml) it may be a bit too long. Cut off a piece of the tube with scissors to make it fit.
  • Fill the print with a liquid soap refill bag and buy those from now on
  • Have fun and enjoy avoiding some plastic waste along the way!

Size of the print: 84 x 76 x 139 mm Photos by Maison Lumiere

Print settings Required build volume: 100 x 100 x 150 mm Material usage: 80g Print time: 6h – 7h

Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 15% Build plate adhesion type: none

Watertight printing: If you have a well set up machine it comes automatically - Otherwise here are some tips: Increase your wall count (at least 3), level your bed nicely, decrease print speed, increase layer height (at least 0.2mm), increase print temperature, check your seam quality, calibrate your e-steps and fine tune your retraction settings to make sure no holes appear after a layer change.


30 Likes54 DownloadsJune 21, 2023


30 Likes54 DownloadsJune 21, 2023
This model is restricted by licensing terms.