gazzaladra

Fruit bowl “Wind”

by
gazzaladra
Follow
Follow
Remix Model
gazzaladra
gazzaladra
|
Image 5 of 9
Fruit bowl “Wind” 3d model
gazzaladra
gazzaladra
|
Image 5 of 9
Fruit bowl “Wind” 3d model
2D
3D
Makes
Fruit bowl “Wind” 3d model
Fruit bowl “Wind” 3d model
Fruit bowl “Wind” 3d model
Fruit bowl “Wind” 3d model
Fruit bowl “Wind” 3d model
Fruit bowl “Wind” 3d model
Fruit bowl “Wind” 3d model
Fruit bowl “Wind” 3d model
Fruit bowl “Wind” 3d model
This model is restricted by licensing terms. 

A big and unique fruit bowl made from 3d printed parts and commercially usual wooden skewers.

Instructions (go along with the images)

  • Print the base, 44 of the connectors_up and 44 of the connectors_down
  • Buy a pack of 100 wooden skewers (you can get them for a few bucks in most supermarkets or online; you only need 88 but you may break one or two during the assembly) Size: 200mm x 3mm
  • Start the assembly: begin pushing in the skewers with the flat end into the base on the LEFT next to the cut out Push in all the skewers and add the connectors counterclockwise ( _up for the upper part; _down for the bottom part)
  • Push the last skewer into the connectors and bend it a little into the cut out.
  • Repeat for the other part
  • Enjoy!

Size assembled: 400 x 400 x 334 mm

Print settings Required build volume: 140 x 140 x 40 mm Material usage overall: 270g Print time overall. 29h

Material: PLA Print direction: stls are rotated correctly, check images Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Outer walls: 3 Infill: 10% Build plate adhesion type: none


14 Likes18 DownloadsJune 6, 2023


14 Likes18 DownloadsJune 6, 2023
This model is restricted by licensing terms.