• Featuring Gingerbread Joe, Gingerbread Jane, Gingerbread Cat, Gingerbread Dog, Gingerbread Penguin, Gingerbread Snowman, Gingerbread Rudolph, Gingerbread Snowflakes, Gingerbread Teddy Bear ✔
• Contains 9 Base and Cap designs ✔
• Support-free ✔
• Keychain version included ✔
• Printable with and without AMS ✔

PRINT SETTINGS RECOMMENDATIONS (for Caps)

• Layer height: 0.2mm
• Line width Default (Quality): 0.33
• Wall generator (Quality): Arachne
• Initial Layer Flow Ratio (Quality): 1.03 (in Develop Mode) (You may adjust this setting as needed depending on your printer’s calibration)
• Only one wall on first layer (Quality): ON
• Bottom Surface Pattern (Strength): Concentric
• Slow down for overhangs (Speed): OFF

PRINT SETTINGS RECOMMENDATIONS (for Bases)

• .20mm Standard @BBL

SWITCHES USED

• Glorious Kailh Switches

If you have any suggestions, please feel free to reach us out!