Trelix, desk pot planter.
450 downloads · 2 years ago · Designed by us, 3D printed by you.
This is Trelix, a pot planter with an integrated trellis and dri
Designed by us, 3D printed by you.
This is Trelix, a pot planter with an integrated trellis and drip tray.
A PDF with 3D printing settings is included.
Trelix, desk pot planter.
450 downloads · 2 years ago in and
Cone, desk/wall pot planter.
Tactican, can accessories.
Inbox, Wall-mounted Mail & Key holder.
Flux, desk lamp.
Shoji, Photo frame & Key holder.
Vista, Photo & key holder.
Allium, glasses holder with storage.
Exo, coaster set.
Nori, Cat house and Coffee Table.
Wick, Desk lamp & Tealight candle holder.
Vertigo, desk vase.
Social battery, desk/door/wall lamp.
HEDRA, Modular Wall Ecosystem - Starter Pack
Rootor, Self-watering spike.
Papaya, Watch & Earbuds charger holder.
Deco, desk vase.
Buzz, Paper clip & push pin dispenser.
Silo, wall mounted kitchen dispenser.
Spool, winding case for sewing measuring tape.
Hi Elle, this model has some issues where the spiral part came out 3 times and was knocked of the plate even after cleaning and maintaining it , can you help here?
Hi! As mentioned in other comments I would suggest to lower the print speed as well as the temperature. I know the spiral part can be tricky to print, please keep me updated.
can you plz tell lower speed setting i pirnted 4 time but no use
i got some trouble printing the Trelix dex pot planter, i'm using an bambu lab a1. at 75%~ it starts to stragger and the tip of the printer Hits the piece.
I try 3 times no succes
Hi, try lowering the speed and the extrusion temperature. Please inform me if it works this time.
When it came to the spiral part, it came out of its place and the printing was interrupted. I couldn't understand whether it was the speed setting or the temperature setting. I used pla+ filament at 190 degrees. I started the speed at low.