
**Disclaimer:**
- These spacers were designed based off of measurements I made on my K1 Series 3D printer. I do not have a K1C or K1 Max, so I can't guarantee that they will work with either of the other printers.
- DO NOT use the printer with the spacers on the lead screws. This could potentially damage the printer.
- The efficacy of these parts rely on the accuracy of your printer, and how well you are able to stabilize the lead screws. Multiple attempts may be necessary.
- Re-Alignment of the bed may not be necessary if you see a maximum deviation of .5mm or less.

**Information:**
These spacers are designed to help address the difficulty in aligning the bed on the K1 series 3D printers from Creality. The top portion of the printer has slight deviances in the heights of the lead screws, and therefore different height spacers are needed. The smallest spacer is designed for the rear lead screw, and the taller spacers for the front screws. The idea is to place these spacers right below the upper most limits of the Z axis, turn the printer over, disengage the Z axis synchronization belt, and manually move the bed down until all 3 points are contacting the spacers. This should allow you to bring the bed to much closer alignment than you previously had.



K1 Z Screw Spacers

K1 Z Screw Spacers.stl

A mount for the Ender 3/Pro/etc that allows for repositioning of the Z Stepper motor, to make the Lead Screw parallel to the frame. It also has a snug fit for an optional Axial Thrust Bearing, which will help reduce sag on worn out/old stepper motors.

Ender 3 Adjustable Z Motor Mount with Bearing Slot

An mount for the Ender 3/Pro/etc that allows for repositioning of the Z Stepper motor, to make the Lead Screw parallel to the frame. It also has a snug fit for an optional Axial Thrust Bearing, which will help reduce sag on worn out/old stepper motors.

A set of fully Parametric Drawers and Housings. The housing models are fully parametric and can be extended along the Width/Length/Height as short or as far as you want. The Drawers can be modified along the Height/Width, but the length will always be the length of the housing.

In some cases where you are adding an incredibly high number of drawers along the Height/Width of the model, you may have to edit "Extrusion 16" in fusion 360.

Gridfinity Parametric Drawers

Gridfinity Parametric Drawers 3x3x4 Housing.step

Just a simple riser tower that slots into the Gridfinity system. It comes with 2 models, a hollow tower with shelves and a solid one.
Both are fully parametric, including the shelves.

Parametric Gridfinity Riser

Gridfinity Riser Parametric.3mf

Gridfinity Hollow Riser 1x1x3 With Shelf.step

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

echotree.prints

Achievements

Seedling

Debutant

Voyager

K1 Z Screw Spacers

Ender 3 Adjustable Z Motor Mount with Bearing Slot

Gridfinity Parametric Drawers

Parametric Gridfinity Riser