Stop removing your pin backs! 🚀

Introducing PInKea V2, the refined evolution of my IKEA Skådis enamel pin support system. After analyzing user feedback and performing several stress tests, I’ve redesigned the piece to make it simpler, faster, and more robust. ** What’s new in V2?**

One-Piece Design: No more back caps or extra parts. The pin slides in and stays secure using its own original clutch/butterfly back.

"Click & Display" System: Just slide the pin into the slot and snap the support into your Skådis board. It takes less than 3 seconds!

Zero-Waste Engineering: Optimized geometry that prints in minutes with almost zero filament waste (~1g).

This Collection Includes 3 Variants: To ensure your pins are always perfectly leveled, this pack includes:

Diagonal Slot (Left/Right): Perfect for pins with offset needles.

Vertical Slot: For standard pins.

Centered Hole: For symmetrical or larger designs. ** Technical Specs:**

No Supports Needed: Designed for 100% clean FDM printing.

Material: Works great in PLA, PETG, or ABS.

Infill: 100% recommended (for maximum tab durability).

Legal & Licensing:

Original design registered at Safe Creative.

Personal Use: Download this pack to organize your own collection.

Commercial License: Want to sell physical 3D prints of this design? You can obtain the official Commercial License by joining my Thangs Membership Plan.