I created this clip to prevent stockings from rotating or twisting when hung from a mantle. As soon as the clip finishes printing, bend each tap upright and hold for a few seconds until the filament has cooled and the part stays in this position. To use - simply install the long leg of the clip into the stocking and then pass the stocking's loop through each tab. That's it, the stocking will return to center if it rotates out of position. There are two tab files, depending on the thickness of your stocking's loop.
0 Likes0 DownloadsDecember 18, 2023
0 Likes0 DownloadsDecember 18, 2023