Inspired by many jibbitz display thingies out there, but unable to find one that suited what the young ones wanted, I put this basic one together.

Printing the pieces separately means that you get a nice finish on the display surface, based on your build plate's pattern. However, I have added an all-in-one if that is your preference (untested).

The display board slots into the base (has a 0.05mm clearances in all directions) and has been pretty stable.

V2 has shorter “keyholes” to reduce the amount of hole seen when displaying small jibbitz. It also has a rounded corners on the top of the board

Printed at 0.20mm layer height with a 0.4mm nozzle using Kiwifil PLA Pro Light Marble filament