Scott M

Christmas Icicle Ornament

by
dazus k
Follow
Follow
Remix Model
dazus k
dazus k
|
Image 2 of 3
Christmas Icicle Ornament 3d model
dazus k
dazus k
|
Image 2 of 3
Christmas Icicle Ornament 3d model
2D
3D
Makes
Christmas Icicle Ornament 3d model
Christmas Icicle Ornament 3d model
Christmas Icicle Ornament - Made about 36 of these for my workplace. I was inspired after seeing the Uncle Jessy he tried his hand at crystal clear resin prints. - 3d model
This model is restricted by licensing terms. 

This may look impossible to print, but I've made it very easy by including a version with built-in supports.

Not for commercial use. Please see license agreement.

I've printed this with both 0.4mm and 0.8mm walls. Both printed really well and resulted in an extremely light ornament. Pictured above is the 0.4mm version printed in Sunlu Clear PLA at 0.1mm layer thickness. Printing took about 4 hours.

With the version that has the supports built-in, you need no other supports, no raft, no brim, and no infill.

You can scale the print up or down as much as you like. At 100%, the final ornament is about 150mm high and 25mm wide. The real challenge with printing it smaller is the star-shaped loop at the top. If you print too hot or you don't have sufficient cooling, then the loop will melt as it prints. I print at 185 C.


33 Likes107 DownloadsNovember 13, 2021



33 Likes107 DownloadsNovember 13, 2021
This model is restricted by licensing terms.