This model is restricted by licensing terms.
View license.
0 Likes3 DownloadsDecember 15, 2023
This model is restricted by licensing terms.
View license.
Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:6207174.
After printing your mold, insert the wick into its joint, tighten the two pieces of the mold (with the help of a bench vise or clamps), and pour the melted wax.
After a few hours (when the wax is solid) your new candle will be ready.
I didn't use any type of lubricant, the wax came off the piece very easily.
To help you detach the two molds from each other, you can help yourself with a screwdriver by inserting it in the 2 holes on the side.
I tried printing this in PLA and it held up to temperatures, i recommend a fairly high filling.
Candle Diameter: 6cm
0 Likes3 DownloadsDecember 15, 2023
This model is restricted by licensing terms.
View license.
0 Likes3 DownloadsDecember 15, 2023
This model is restricted by licensing terms.
View license.