Bring mystical elegance to your cosplay, fantasy costumes, or collectible displays with these Sorceress Bracers.

Each bracer comes precut, preslotted.

Perfect for mages, elves, battle sorceresses, RPG characters, or stylized fantasy warriors.

📐 Measuring Instructions (Cosplay Size)

Measure around the widest part of your forearm, approximately 8–10 cm below the elbow.

Measure the length from wrist crease to the point you want the bracer to end.

Scale the bracer uniformly in your slicer so the inner cavity matches your two measurements.

If unsure, print a thin 1–2 cm test rings (upper and lower) to confirm fit before printing the full piece.

📏 Measuring Instructions (Action Figures / Dolls)

Measure the figure’s forearm circumference with a string or calipers.

Measure the forearm length you want the bracer to cover.

Scale uniformly until the inner diameter fits those measurements.

For very small scales, resin printing recommended.

🖨️ Printing Tips

Works great on FDM (0.12–0.2 mm layer height) or resin

Print pieces flat-side down for best strength

Use superglue + activator for instant assembly

For durability on cosplay scale, increase wall thickness to 3–4 perimeters

🎨 Finishing Suggestions

Sand lightly and prime with your preferred filler-primer

Metallic paints or pearlescent finishes look incredible with the ornamentation

Shadows pop beautifully with a dark wash

Optional: Add leather straps or elastic bands to the slots

A hairdryer or heat gun (low setting) can fine-tune curvature for a perfect fit