David K

Multiboard route-behind cable holder

by
d.j.k
Follow
Follow
Remix Model
d.j.k
d.j.k
|
Image 4 of 4
Multiboard route-behind cable holder 3d model
d.j.k
d.j.k
|
Image 4 of 4
Multiboard route-behind cable holder 3d model
2D
3D
Makes
Multiboard route-behind cable holder 3d model
Multiboard route-behind cable holder 3d model
Multiboard route-behind cable holder 3d model
Multiboard route-behind cable holder 3d model
This model is restricted by licensing terms. 

I wanted an easy way to route and retain cables behind an existing offset mount multiboard.

File works with a 15 mm offset board, and mounts using a 13 mm small thread shank bolt, like this one .

Use: The part loads into a placement tool to allow easy positioning. After positioning the part, advance the bolt until flush with the base of the cable holder, remove the positioning tool, slide the cable into place, then finish tightening.


23 Likes66 DownloadsJanuary 31, 2024



23 Likes66 DownloadsJanuary 31, 2024
This model is restricted by licensing terms.